Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 1999 Feb 12;17(6):512-29.
doi: 10.1016/s0264-410x(98)00229-1.

The stability and immunogenicity of a protein antigen encapsulated in biodegradable microparticles based on blends of lactide polymers and polyethylene glycol

Affiliations

The stability and immunogenicity of a protein antigen encapsulated in biodegradable microparticles based on blends of lactide polymers and polyethylene glycol

E C Lavelle et al. Vaccine. .

Abstract

Protein-loaded microparticles were produced from blends of poly(ethylene glycol) (PEG) with poly(L-lactide) (PLA) homopolymer or poly(DL-lactide co-glycolide) copolymers (PLG) using a water-in oil-in oil method. The stability of ovalbumin (OVA) associated with microparticles prepared using PEG and 50:50 PLG, 75:25 PLG and PLA, respectively, was analysed by SDS-PAGE and quantified by scanning densitometry following incubation in PBS at 37 degrees C for up to 1 month. Fragmentation and aggregation of OVA was detected with all 3 formulations. The extent of both processes correlated with the degradation rate of the lactide polymer used and decreased in the order PLA < 75:25 PLG < 50:50 PLG. Extensive degradation of the PLG/PEG microparticles also occurred over 4 weeks whereas the use of PLA/PEG blends resulted in a stable microparticle morphology and much reduced fragmentation and aggregation of the associated protein. Following a single sub-cutaneous immunisation, high levels of specific serum IgG antibody were elicited by OVA associated with the PLA/PEG particles. Injection of OVA associated with the 75:25 PLG/PEG microparticles resulted in very low levels of specific antibody. A higher response was induced by the 50:50 PLG/PEG formulation but there was very large inter-animal variation in this group. Antibody levels elicited by all 3 formulations were significantly higher than those elicited by a single injection of soluble OVA. Analysis of antigen specific IgG1 and IgG2a antibody subtype levels also revealed the greater efficacy of the PLA/PEG microparticles as an adjuvant system. The use of PLA/PEG microparticles shows improved protein loading and delivery capacity while maintaining a high level of stability of the associated protein. These results indicate a strong correlation between the stability of microencapsulated antigen and the magnitude of the immune response following sub-cutaneous immunisation.

PubMed Disclaimer

MeSH terms

LinkOut - more resources