Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 1999 Oct;44(4):439-43.
doi: 10.1093/jac/44.4.439.

Gradient plate method to induce Streptococcus pyogenes resistance

Affiliations

Gradient plate method to induce Streptococcus pyogenes resistance

H Carsenti-Etesse et al. J Antimicrob Chemother. 1999 Oct.

Abstract

In recent years, increasing numbers of Streptococcus pyogenes (GAS) strains displaying resistance to macrolides have been reported in Finland, Japan, Asia and Spain. Antibiotic use has been shown to be a risk factor for infection with and carriage of drug-resistant streptococci. The aim of this study was to compare in-vitro development of resistance of streptococci to beta-lactams (penicillin, amoxycillin, cefotiam and cefuroxime) and erythromycin by serial passages in subinhibitory concentrations of antibiotics (subMICs) by gradient plate method. Three clinical strains of GAS were tested. Two were susceptible to erythromycin (MIC = 0.015 mg/L and 0.013 mg/L) and one resistant. Serial passages were performed daily by gradient plate method until a four-fold increase of the MIC was achieved. GAS variants obtained after serial passages in beta-lactams had MICs increased at least four-fold. They remained susceptible to these antibiotics. With erythromycin, final MICs reached intermediate and resistant level. Results obtained in this study with erythromycin are in good correlation with clinical studies showing that prior exposure to macrolides may help to facilitate the emergence of drug-resistant strains of streptococci.

PubMed Disclaimer

Comment in

MeSH terms

LinkOut - more resources