Variation of cellulose microfibril angles in softwoods and hardwoods-a possible strategy of mechanical optimization

Abstract

Position-resolved small-angle X-ray scattering was used to investigate the nanostructure of the wood cell wall in two softwood species (Norwegian spruce and Scots pine) and two hardwood species (pedunculate oak and copper beech). The tilt angle of the cellulose fibrils in the wood cell wall versus the longitudinal cell axis (microfibril angle) was systematically studied over a wide range of annual rings in each tree. The measured angles were correlated with the distance from the pith and the results were compared. The microfibril angle was found to decrease from pith to bark in all four trees, but was generally higher in the softwood than in the hardwood. In Norwegian spruce, the microfibril angles were higher in late wood than in early wood; in Scots pine the opposite was observed. In pedunculate oak and copper beech, low angles were found in the major part of the stem, except for the very first annual rings in pedunculate oak. The results are interpreted in terms of mechanical optimization. An attempt was made to give a quantitative estimation for the mechanical constraints imposed on a tree of given dimensions and to establish a model that could explain the general decrease of microfibril angles from pith to bark.