Increment technique for extended Class V restorations: an experimental study

Abstract

The application and polymerization of composite or polyacid-modified resin composites in thin layers (increment technique) for filling cavities might partially compensate for the stress associated with polymerization shrinkage. In this study, the effect of this technique on the marginal integrity of Class V polyacid-modified composite restorations was investigated. In 30 extracted premolars, extended Class V cavities were prepared with the apical margin in root dentin and the coronal margin in enamel. They were then subjected to different treatments (10 teeth in each case): a) placement and polymerization of a thin resin composite layer (Dyract-Dyract PSA) in the coronal part of the cavity (plus one increment for the residual part) (Group 1), b) a thin layer at the apical part of the cavity (plus one increment for the residual part) (Group 2) and c) restoration of the entire cavity with one increment (bulk technique) (Group 3). Following three days' storage in water, the teeth were subjected to cyclic thermal loading (4 degrees C <-> 55 degrees C, 2,000 cycles). The percentages of defective bonding detected along the total length of the restoration margin were assessed before and after thermocycling by scanning electron microscopy. Following loading and thermocycling, no significant differences were found at the restoration-enamel interface. Fewer gaps were found at the restoration-dentin interface in Group 1 (18.7 +/- 25.7%) and Group 2 (20.5 +/- 22.8%) compared to the reference Group 3 (42.2 +/- 30.6%) (Mann-Whitney U test: p<0.05). Moreover, there were no significant differences between the two increment groups (1 and 2). In a significantly larger number of cases, a completely intact dentin restoration margin was detected when a coronal increment (Group 1) (44.4%) was used instead of the bulk technique (Group 3) (13.6%) (Chi square test: p<0.05). These results indicate that gap formation can be significantly minimized by using an increment technique to restore extended Class V cavities with polyacid-modified composite materials.