Surface properties of rat pulmonary surfactant studied with the captive bubble method: adsorption, hysteresis, stability

Abstract

Surface tension-area relations from pulmonary surfactant were obtained with a new apparatus that contains a leak free captive bubble of controllable size. Rat pulmonary surfactant was studied at phospholipid concentrations of 50, 200 and 400 micrograms/ml. At the highest concentration, adsorption was rapid, reaching surface tensions below 30 mN/m within 1 s, while at the lowest concentration, approximately 3 min were required. Upon a first quasi static or dynamic compression, stable surface tensions below 1 mN/m could be obtained by a film area reduction of approximately 50%. After three to four cycles the surface tension-area relations became stationary, and the tension fell from 25-30 to approximately 1 mN/m for a film area reduction of less than 20%. Hysteresis became negligible, provided the films were not collapsed by further area reduction. Under these conditions, the films could be cycled for more than 20 min without any noticeable loss in surface activity. After only three to four consecutive cycles, surfactant films exhibited the low surface tensions, collapse rates and compressibilities characteristic of alveolar surfaces in situ. Remarkably, surface tension and area are interrelated in the captive bubble which may promote low and stable surface tensions. If the surface tension of the captive bubble suddenly increases ('click') because of mechanical vibration or unstable surfactant, the bubble shape changes from flat to more spherical. The associated isovolumetric decrease in surface area prevents the surface tension from rising as much as it would have in a constant-area situation. This feedback mechanism may also have a favorable effect in stabilizing alveolar surface tension at low lung volumes.