The use of ultrafiltration and nanofiltration membranes for the purification of cork processing wastewater

Abstract

Filtration experiments in batch concentration mode (with recycling of the retentate stream) of the cork processing wastewater were performed in laboratory filtration membrane equipment, by using four commercial membranes: two UF membranes with MWCO of 20,000 and 5000 Da, and two NF membranes with an approximate MWCO of 150-300 Da. The filtration experiments of the selected wastewater were performed by modifying the most important operating variables: transmembrane pressure, tangential velocity, temperature, and the nature and MWCO of the membranes. The evolution of the cumulative permeate volumes and permeate fluxes with processing time were analysed, and it was established that the steady-state permeate flux was reached for a volume retention factor of 2. The effect of the mentioned operating conditions on this steady-state permeate flux was discussed. The effectiveness of the filtration treatments was determined by the evaluation of the rejection coefficients for several parameters, which measure the global pollutant content of the effluent: COD, absorbance at 254 nm, tannic content, color, and ellagic acid. Finally, the resistances in series model was used for the evaluation of the resistances to the permeate flux, and it was concluded that the contribution to the total resistance of the fouling resistance (combined external plus internal) was higher than the inherent resistance of the clean membrane.