Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 2008 Dec;134(6):820-6.
doi: 10.1016/j.ajodo.2007.11.026.

Integration of digital dental casts in 3-dimensional facial photographs

Frits A Rangel  1 , Thomas J J Maal, Stefaan J Bergé, Olivier J C van Vlijmen, Joanneke M Plooij, Filip Schutyser, Anne Marie Kuijpers-Jagtman
Affiliations

Integration of digital dental casts in 3-dimensional facial photographs

Frits A Rangel et al. Am J Orthod Dentofacial Orthop. 2008 Dec.

Abstract

Introduction: Since 1915, various researchers have tried to make a 3-dimensional (3D) model of the complete face, with the dentition in the anatomically correct position. This was a difficult and time-consuming process. With the introduction of 3D digital imaging of the face and dental casts, researchers have regained interest in this topic. The purpose of this technical report is to present a feasibility study of the integration of a digital dental cast into a 3D facial picture.

Methods: For the integration, 3 digital data sets were constructed: a digital dental cast, a digital 3D photograph of the patient with the teeth visible, and a digital 3D photograph of the patient with the teeth in occlusion. By using a special iterated closest point algorithm, these 3 data sets were matched to place them in the correct anatomical position.

Results: After matching the 3 data sets, we obtained a 3D digital model with the dental cast visible through the transparent picture of the patient's face. When the distance between the matched data sets was calculated, an average distance of 0.35 mm (SD, 0.32 mm) was shown. This means that matching the data sets is acceptable.

Conclusions: It seems technically possible to make a data set of a patient's face with the dentition positioned into this 3D picture. Future research needs to establish the value of this 3D fused data set of the face and the dentition in orthodontic diagnosis and treatment planning.

PubMed Disclaimer