Impact of the X-ray system setting on patient dose and image quality; a case study with two interventional cardiology systems

Abstract

This study investigates the influence of the initial X-ray system setting on patient doses and image quality in interventional cardiology procedures. Two dedicated interventional cardiology systems were studied: a system with image intensifier (II) and a flat detector (FD) system. Entrance surface air kerma (ESAK) rates in fluoroscopy and ESAK per frame in the acquisition mode were measured on the surface of a PMMA phantom for the field of views (FOV) of 23 and 17 cm (II system) and 25 and 20 cm (FD system). Signal-to-noise ratio (SNR) and contrast-to-noise ratio (CNR) were estimated using DICOM images obtained during the measurements. System performances were compared using a figure of merit combining SNR and ESAK. The influence of system setting on patient doses was investigated analysing the information for air kerma area product (KAP) and cumulative dose (CD) at the patient entrance reference point, for a sample of coronary angiography examinations. ESAK rates in fluoroscopy modes were a factor of 2 higher in the FD system for the similar FOVs, resulting in a factor of 1.9 higher median values of KAP and CD for patients with FD system than for the II system. SNR and CNR for the FD system were better than the equivalent FOVs with II. The resulting FOM was better for the FD system in both FOVs. Potential for optimisation was suggested by adjusting system settings.