Axial view of acetabular anterior column: a new X-ray projection of percutaneous screw placement

Abstract

Introduction: To search for a new radiographic view/projection of the acetabular anterior column to provide a safe guide for percutaneous screw placement for acetabular fractures.

Materials and methods: Eight pelvic specimens taken from normal adult cadavers were positioned in a supine position on the operating table. First, the ipsilateral ilium-oblique view of the observed side was obtained on C-arm fluoroscopy by tilting the C-arm approximately 35° toward the contralateral hip joint. Then, the tilting angle of the C-arm was changed gradually until an oval track image (acetabular anterior column axial view) appeared. The oval shadow was clear only in one position as the angle of the C-arm was changed toward the caudal side of the operating table. A guide pin was put on the skin of the cadaver, and the location and tilting direction of the guide pin were adjusted under C-arm fluoroscopy until the pin's shadow became a point in the center of the oval track. Then, the guide pin was inserted into the bone using a battery-powered drill. The degree of inclination of the guide pin in the cadaver in the frontal and sagittal planes was measured using computed tomography (CT).

Results: Axial views of the anterior column were found successfully in all of the pelvic specimens, and the guide pins were inserted accurately into the acetabular anterior column under C-arm fluoroscopic guidance. On the CT-reconstructed image, the average degree of angle between the guide pin and the sagittal plane was 33.6° (range 29.6°-36.5°). The average angle between the guide pin and the transverse plane was 59.1° (range 56.4°-63.2°).

Conclusion: This axial view of the acetabular anterior column is a novel X-ray projection which provides an optimal method for guiding percutaneous insertion of anterior column screws for acetabular fractures.