Investigating the effect of sterilisation methods on the physical properties and cytocompatibility of methyl cellulose used in combination with alginate for 3D-bioplotting of chondrocytes

Abstract

For both the incorporation of cells and future therapeutic applications the sterility of a biomaterial must be ensured. However, common sterilisation techniques are intense and often negatively impact on material physicochemical attributes, which can affect its suitability for tissue engineering and 3D printing. In the present study four sterilisation methods, autoclave, supercritical CO₂ (scCO₂) treatment, UV- and gamma (γ) irradiation were evaluated regarding their impact on material properties and cellular responses. The investigations were performed on methyl cellulose (MC) as a component of an alginate/methyl cellulose (alg/MC) bioink, used for bioprinting embedded bovine primary chondrocytes (BPCs). In contrast to the autoclave, scCO₂ and UV-treatments, the γ-irradiated MC resulted in a strong reduction in alg/MC viscosity and stability after extrusion which made this method unsuitable for precise bioprinting. Gel permeation chromatography analysis revealed a significant reduction in MC molecular mass only after γ-irradiation, which influenced MC chain mobility in the Ca²⁺-crosslinked alginate network as well as gel composition and microstructure. With regard to cell survival and proteoglycan matrix production, the results determined UV-irradiation and autoclaving as the best candidates for sterilisation. The scCO₂-treatment of MC resulted in an unfavourable cell response indicating that this method needs careful optimisation prior to application for cell encapsulation. As proven by consistent FT-IR spectra, chemical alterations could be excluded as a cause for the differences seen between MC treatments on alg/MC behaviour. This investigation provides knowledge for the development of a clinically appropriate 3D-printing-based fabrication process to produce bioengineered tissue for cartilage regeneration.