Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 2019 Dec 20;25(1):35.
doi: 10.3390/molecules25010035.

Graphene Oxide@3D Hierarchical SnO2 Nanofiber/Nanosheets Nanocomposites for Highly Sensitive and Low-Temperature Formaldehyde Detection

Kechuang Wan  1 , Jialin Yang  1 , Ding Wang  1 , Xianying Wang  1
Affiliations

Graphene Oxide@3D Hierarchical SnO2 Nanofiber/Nanosheets Nanocomposites for Highly Sensitive and Low-Temperature Formaldehyde Detection

Kechuang Wan et al. Molecules. .

Abstract

In this work, we reported a formaldehyde (HCHO) gas sensor with highly sensitive and selective gas-sensing performance at low operating temperature based on graphene oxide (GO)@SnO2 nanofiber/nanosheets (NF/NSs) nanocomposites. Hierarchical SnO2 NF/NSs coated with GO nanosheets showed enhanced sensing performance for HCHO gas, especially at low operating temperature. A series of characterization methods, including X-ray diffraction (XRD), Field emission scanning electron microscopy (FE-SEM), Transmission electron microscope (TEM), X-ray photoelectron spectroscopy (XPS) and Brunauer-Emmett-Teller (BET) were used to characterize their microstructures, morphologies, compositions, surface areas and so on. The sensing performance of GO@SnO2 NF/NSs nanocomposites was optimized by adjusting the loading amount of GO ranging from 0.25% to 1.25%. The results showed the optimum loading amount of 1% GO in GO@SnO2 NF/NSs nanocomposites not only exhibited the highest sensitivity value (Ra/Rg = 280 to 100 ppm HCHO gas) but also lowered the optimum operation temperature from 120 °C to 60 °C. The response value was about 4.5 times higher than that of pure hierarchical SnO2 NF/NSs (Ra/Rg = 64 to 100 ppm). GO@SnO2 NF/NSs nanocomposites showed lower detection limit down to 0.25 ppm HCHO and excellent selectivity against interfering gases (ethanol (C2H5OH), acetone (CH3COCH3), methanol (CH3OH), ammonia (NH3), methylbenzene (C7H8), benzene (C6H6) and water (H2O)). The enhanced sensing performance for HCHO was mainly ascribed to the high specific surface area, suitable electron transfer channels and the synergistic effect of the SnO2 NF/NSs and GO nanosheets network.

Keywords: GO@SnO2 NF/NSs; formaldehyde gas sensors; nanocomposites; three-dimensional nanostructure.

PubMed Disclaimer

Conflict of interest statement

The authors declare that they have no competing interests.

Figures

Figure 1
Figure 1
XRD patterns of (a) GO, (b) SnO2 NF/NSs and (c–g) GO@SnO2 NF/NSs nanocomposites with different GO content.
Figure 2
Figure 2
Raman spectra of pure SnO2 NF/NSs, 1% GO@SnO2 NF/NSs and pure GO nanosheets.
Figure 3
Figure 3
SEM images of the as-prepared (a) and (d) SnO2 NF/NSs, (b) and (e) 1% GO@SnO2 NF/NSs and (c) and (f) GO; (g) low magnification TEM image; (h) low magnification TEM image, (i) HRTEM image of the 1% GO@SnO2 NF/NSs nanocomposites.
Figure 4
Figure 4
XPS spectra of SnO2 NF/NSs and 1% GO@SnO2 NF/NSs nanocomposites: (a) survey of 1% GO@SnO2 NF/NSs nanocomposite, (b) C 1s of 1% GO@SnO2 NF/NSs nanocomposites, (c,d) O 1s of pure SnO2 NF/NSs and 1% GO@SnO2 NF/NSs nanocomposites, respectively.
Figure 5
Figure 5
(a) The responses of gas sensors toward 100 ppm formaldehyde at different operation temperatures. (b) Responses of the gas sensors to different test gases at their respective optimal operating temperatures. (c) Response of 1% GO@SnO2 NF/NSs nanocomposites toward HCHO gas in concentration ranges of 0.25–100 ppm at 60 °C. (d) Linear approximation of the detection limit with 1% GO@SnO2 NF/NSs nanocomposite.
Figure 6
Figure 6
Schematic illustration of HCHO gas sensing mechanism for (a) pure SnO2 NF/NSs and GO@SnO2 NF/NSs nanocomposite; (b) the energy band structures of GO@SnO2 NF/NSs nanocomposite in different gas atmospheres.
Scheme 1
Scheme 1
A schematic demonstration of the preparation process of GO@SnO2 NF/NSs nanocomposites.
Figure 7
Figure 7
(a) The schematic structure and (b) the working principle of the gas-sensing test system of the gas sensor.
See this image and copyright information in PMC

References

    1. Zhang D., Liu J., Jiang C., Liu A., Xia B. Quantitative detection of formaldehyde and ammonia gas via metal oxide-modified graphene-based sensor array combining with neural network model. Sens. Actuators B. 2017;240:55–65. doi: 10.1016/j.snb.2016.08.085. - DOI
    1. Meng F., Zheng H., Chang Y., Zhao Y., Li M., Wang C., Sun Y., Liu J. One-step synthesis of Au/SnO2/RGO nanocomposites and their VOC sensing properties. IEEE Trans. Nanotechnol. 2018;17:212–219. doi: 10.1109/TNANO.2017.2789225. - DOI
    1. Yoosefian M., Raissi H., Mola A. The hybrid of Pd and SWCNT (Pd loaded on SWCNT) as an efficient sensor for the formaldehyde molecule detection: A DFT study. Sens. Actuators B. 2015;212:55–62. doi: 10.1016/j.snb.2015.02.004. - DOI
    1. Chung P.R., Tzeng C.T., Ke M.T., Lee C.Y. Formaldehyde gas sensors: A review. Sensors. 2013;13:4468–4484. doi: 10.3390/s130404468. - DOI - PMC - PubMed
    1. Rong X., Chen D., Qu G., Li T., Zhang R., Sun J. Effects of graphene on the microstructures of SnO2@rGO nanocomposites and their formaldehyde-sensing performance. Sens. Actuators B. 2018;269:223–237. doi: 10.1016/j.snb.2018.04.176. - DOI

LinkOut - more resources