Variations in medial and lateral slope and medial proximal tibial angle
- PMID: 32390118
- DOI: 10.1007/s00167-020-06052-y
Variations in medial and lateral slope and medial proximal tibial angle
Abstract
Purpose: The primary objective of this study was to quantify the variations of the medial posterior tibial slope (MPTS) and the lateral posterior tibial slope (LPTS), as well as of the medial proximal tibial angle (MPTA), and to determine the fraction of patients for which standard techniques including different alignment techniques would result in alteration of the patient's individual posterior tibial slope (PTS) and MPTA. Furthermore, it was of interest if a positive correlation between PTS and MPTA or between medial and lateral slope exists.
Methods: A retrospective study was performed on CT-scans of 234 consecutively selected European patients undergoing individual total knee replacement. All measurements were done on three-dimensional CAD models, which were generated on the basis of individual CT-scans, including the hip, knee, and ankle center. Measurements included the medial and lateral PTS and the MPTA. PTS was measured as the angle between the patient's articular surface and a plane perpendicular to the mechanical axis of the tibia in the sagittal plane. MPTA was defined as the angle between the tibial mechanical axis and the proximal articular surface of the tibia in the coronal plane.
Results: Analysis revealed a wide variation of the MPTS, LPTS, and MPTA among the patients. MPTS and LPTS varied significantly both interindividually and intraindividually. The range of PTS was up to 20° for MPTS (from - 4.3° to 16.8°) and for LPTS (from - 2.9 to 17.2°). The mean intraindividual difference between MPTS and LPTS in the same knee was 2.6° (SD 2.0) with a maximum of 9.5°. MPTA ranged from 79.8 to 92.1° with a mean of 86.6° (SD ± 2.4). Statistical analysis revealed a weak positive correlation between MPTA and MPTS.
Conclusion: The study demonstrates a huge interindividual variability in PTS and MPTA as well as significant intraindividual differences in MPTS and LPTS. Therefore, the question arises, whether the use of standard techniques, including fixed PTSs and MPTAs, is sufficient to address every single patient's individual anatomy.
Level of evidence: III.
Keywords: Slope; Tibia anatomy; Tibia angle; Tibia geometry; Total knee arthroplasty; Total knee replacement.
References
-
- Bellemans J, Robijns F, Duerinckx J, Banks S, Vandenneucker H (2005) The influence of tibial slope on maximal flexion after total knee arthroplasty. Knee Surg Sports Traumatol Arthrosc 13:193–196 - DOI
-
- Bourne RB, Chesworth BM, Davis AM, Mahomed NN, Charron KDJ (2010) Patient satisfaction after total knee arthroplasty: who is satisfied and who is not? Clin Orthop Relat Res 468:57–63 - DOI
-
- Dossett HG, Estrada NA, Swartz GJ, LeFevre GW, Kwasman BG (2014) A randomised controlled trial of kinematically and mechanically aligned total knee replacements: two-year clinical results. Bone Jt J 96:907–913 - DOI
-
- Haddad B, Konan S, Mannan K, Scott G (2012) Evaluation of the posterior tibial slope on MR images in different population groups using the tibial proximal anatomical axis. Acta Orthop Belg 78:757–763 - PubMed
-
- Hashemi J, Chandrashekar N, Gill B, Beynnon BD, Slauterbeck JR, Schutt RC, Mansouri H, Dabezies E (2008) The geometry of the tibial plateau and its influence on the biomechanics of the tibiofemoral joint. J Bone Jt Surg Am 90:2724–2734 - DOI
MeSH terms
LinkOut - more resources
Full Text Sources
Medical
Research Materials
Miscellaneous

