Color stability and marginal adaptation of ceramic veneers cemented using different composite resins

Abstract

Background: The purpose of this study was to compare the color stability and marginal adaption of lithium disilicate veneers before and after thermocycling using various resin composite materials employed as cement.

Methods: Laminate veneer preparation was done on an acrylic tooth according to standardized procedures. The veneer preparations were duplicated into twenty-one dies. The veneers were fabricated from lithium disilicate using the CEREC in Lab system. According to the cement type, the twenty-one die specimens were randomly divided into three equal groups: group I, with light cured adhesive resin cement (N.=7), group II, with flowable light cured composite, and group III, with preheated nano filled composite. The cemented specimens underwent 5000 thermocycling cycles. Color was assessed using a reflective spectrophotometer. The vertical marginal gap, following cementation and thermocycling, was measured using a digital microscope. One-way ANOVA followed by Tukey's post-hoc test was used to statistically assess the data.

Results: After thermocycling, there was no statistically significant difference in ΔE among cement type groups for color stability (P=0.369). However, the preheated composite showed the lowest ΔE mean values. Within adhesive resin cement and flowable composite groups, marginal gap means values recorded after thermocycling were significantly higher than those after cementation (P=0.013 and P<0.001, respectively).

Conclusions: Although preheated composite cement showed the highest marginal discrepancy, it would be the best choice regarding color stability.