Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 2023 Jun 28:11:1225187.
doi: 10.3389/fbioe.2023.1225187. eCollection 2023.

Effects of bubble cutting dynamic behaviors on microalgal growth in bubble column photobioreactor with a novel aeration device

Sha Zhao  1 , Wenyue Feng  1 , Jinming Li  1 , Xiaoguang Zhang  1 , Li Liu  1 , Hongyan Li  1
Affiliations

Effects of bubble cutting dynamic behaviors on microalgal growth in bubble column photobioreactor with a novel aeration device

Sha Zhao et al. Front Bioeng Biotechnol. .

Abstract

Introduction: Carbon sequestration by microalgae is an effective approach for achieving carbon neutrality owing to its high carbon capture efficiency and environmental friendliness. To improve microalgae CO2 fixation efficiency, various methods to enhance CO2 transfer at the gas-liquid interface have resulted in high energy consumption. Methods: In this study, a novel aeration device with bubble cutting slices was installed in a photobioreactor for CO2 supply, which could precisely separate bubbles into sizes on the way to rising after departure, achieving CO2 transfer enhancement without extra energy consumption. Subsequently, the bubble cutting dynamic behaviors in the photobioreactor were studied, and the effects of thickness, hydrophilicity, and arrangement of cutting slices on microalgal growth were analyzed. Results: It was found that bubble cutting caused the maximum dry weight and biomass productivity of microalgae to improve by 6.99% and 33.33%, respectively, compared with those of the bioreactor without cutting units, owing to a 27.97% and 46.88% decrease in bubble size and rising velocity, respectively, and an 84.55% prolongation of bubble residence time. Discussion: Parallel cut slices with a thickness and spacing of less than 3 mm successfully cut the bubbles. The hydrophobic slice surface prevented daughter bubble departure and prolonged the bubble residence time, impeding microalgae growth owing to bubble coalescence with subsequent bubbles. The optimal cutting slice parameters and culture conditions for microalgal growth were 1 mm slice thickness, less than 1 mm slice spacing, 5% inlet CO2 concentration, and 70 mL/min gas flow rate.

Keywords: aeration device; bubble cutting; chlorella pyrenoidosa; hydrophilicity; microalgae carbon sequestration; visualization.

PubMed Disclaimer

Conflict of interest statement

The authors declare that the research was conducted in the absence of any commercial or financial relationships that could be construed as a potential conflict of interest.

Figures

FIGURE 1
FIGURE 1
Effects of bubble cutting dynamic behaviors on microalgal growth in bubble column photobioreactor with a novel aeration device (A) Schematic of the experimental setup (B) Picture of the experimental setup.
FIGURE 2
FIGURE 2
Effects of bubble behaviors on microalgal growth with cutting units in the bioreactor (cutting units:δ = 1 mm, M = 0, gg) (A) Bubble deformation process during bubble cutting (B) Distribution of bubble diameter in the height direction of bioreactor (C) Growth curve of Chlorella pyrenoidosa (D) Variation of pH during algal growth.
FIGURE 3
FIGURE 3
Effects of cutting units thickness on bubble behaviors and microalgal growth (cutting units: M = 0, gg) (A) Distribution of bubble diameter in the height direction of bioreactor (B) Growth curve of Chlorella pyrenoidosa (C) Variation of pH during algal growth.
FIGURE 4
FIGURE 4
Effects of cutting units hydrophilicity on bubble behaviors and microalgal growth (cutting units:δ = 1 mm, M = 0) (A) Distribution of bubble diameter in the height direction of the bioreactor (B) Growth curve of Chlorella pyrenoidosa (C) Variation of pH during algal growth.
FIGURE 5
FIGURE 5
Effects of cutting units arrangement on bubble behaviors and microalgal growth (cutting units:δ = 0.15 mm, gg) (A) Distribution of bubble diameter in the height direction of the bioreactor (B) Growth curve of Chlorella pyrenoidosa (C) Variation of pH during algal growth.
FIGURE 6
FIGURE 6
Performance of the optimal aeration device in microalgae photobioreactor (cutting units: δ = 1 mm, M = 0 mm, gg) (A) Variation of growth curve with different inlet CO2 concentrations (B) Variation of pH with different inlet CO2 concentrations (C) Variation of growth curve with different gas flow rates (D) Variation of pH with different gas flow rates.
See this image and copyright information in PMC

References

    1. Baltussen M. W., Kuipers J. A. M., Deen N. G. (2017). A numerical study of cutting bubbles with a wire mesh. Chem. Eng. Sci. 165, 25–32. 10.1016/j.ces.2017.01.037 - DOI
    1. Bitog J. P., Lee I. B., Lee C. G., Kim K. S., Hwang H. S., Hong S. W., et al. (2011). Application of computational fluid dynamics for modeling and designing photobioreactors for microalgae production: A review. Comput. Electron. Agric. 76, 131–147. 10.1016/j.compag.2011.01.015 - DOI
    1. Chang H., Feng H., Wang R., Zhang X., Wang J., Li C., et al. (2023). Enhanced energy recovery from landfill leachate by linking light and dark bio-reactions: Underlying synergistic effects of dual microalgal interaction. Water Res. 231, 119578. 10.1016/j.watres.2023.119578 - DOI - PubMed
    1. Cheng J., Lai X., Ye Q., Guo W., Zhou J. (2020). Numerical simulation on optimizing flow field and flashing-light effect in jet-aerated tangential swirling-flow plate photobioreactor to improve microalgal growth. Chem. Eng. Sci. 215, 115371. 10.1016/j.ces.2019.115371 - DOI
    1. Cheng J., Song Y., Guo W., Miao Y., Chen S., Zhou J. (2019). Developing microporous fibrous-diaphragm aerator to decrease bubble generation diameter for improving microalgal growth with CO2 fixation in a raceway pond. Bioresour. Technol. 276, 28–34. 10.1016/j.biortech.2018.12.090 - DOI - PubMed

LinkOut - more resources