Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 2024 Jan 19;6(2):853-861.
doi: 10.1021/acsaelm.3c01390. eCollection 2024 Feb 27.

Local Environment of Sc and Y Dopant Ions in Aluminum Nitride Thin Films

Affiliations

Local Environment of Sc and Y Dopant Ions in Aluminum Nitride Thin Films

Asaf Cohen et al. ACS Appl Electron Mater. .

Abstract

The local environments of Sc and Y in predominantly ⟨002⟩ textured, Al1-xDoxN (Do = Sc, x = 0.25, 0.30 or Y, x = 0.25) sputtered thin films with wurtzite symmetry were investigated using X-ray absorption (XAS) and photoelectron (XPS) spectroscopies. We present evidence from the X-ray absorption fine structure (XAFS) spectra that, when x = 0.25, both Sc3+ and Y3+ ions are able to substitute for Al3+, thereby acquiring four tetrahedrally coordinated nitrogen ligands, i.e., coordination number (CN) of 4. On this basis, the crystal radius of the dopant species in the wurtzite lattice, not available heretofore, could be calculated. By modeling the scandium local environment, extended XAFS (EXAFS) analysis suggests that when x increases from 0.25 to 0.30, CN for a fraction of the Sc ions increases from 4 to 6, signaling octahedral coordination. This change occurs at a dopant concentration significantly lower than the reported maximum concentration of Sc (42 mol % Sc) in wurtzite (Al, Sc)N. XPS spectra provide support for our observation that the local environment of Sc in (Al, Sc)N may include more than one type of coordination.

PubMed Disclaimer

Conflict of interest statement

The authors declare no competing financial interest.

Figures

Figure 1
Figure 1
XRD patterns of Al0.75Sc0.25N and Al0.70Sc0.30N thin films grown on ⟨100⟩ cut Si wafers with a 50 nm Ti seeding layer. The substrate is tilted 3° in order to minimize diffraction from the Si substrate.
Figure 2
Figure 2
XRD pattern of an Al0.75Y0.25N thin film grown on ⟨100⟩ cut Si with a 50 nm Ti seeding layer. A pattern with full 2θ range is included in the SI (Figure S1). The substrate has been tilted 3° in order to minimize diffraction from the Si substrate.
Figure 3
Figure 3
SEM images of the surface and cross-section of thin films (a diamond pen was used to prepare cross sections) of (a) Al0.75Sc0.25N, reproduced with permission from ref (17). (b) Al0.70Sc0.30N and (c) Al0.75Y0.25N, respectively. Pebble-like grains (84–94 nm) appear on the surface in panels (a) and (b), along with columnar growth. Grain size decreases with increasing Sc concentration. Disoriented, abnormal grains are observed on the surface of Al0.70Sc0.30N. We noted in our earlier report that during reactive sputtering of AlScN, the final deposition temperature influences the number of abnormally oriented grains visible in SEM images. In panel (c), individual grains and grain size on the film surface are difficult to distinguish, indicating a tendency to poor crystallinity, as has been reported in the literature. All scale bars indicate 1 μm.
Figure 4
Figure 4
Sc K-edge XANES spectra of Al0.75Sc0.25N (black trace), Al0.7Sc0.3N (red trace) thin films, and ScN (blue trace) powder. Note the absence of a pre-edge peak for ScN.
Figure 5
Figure 5
(a) k2-weighted EXAFS spectra of Al0.75Sc0.25N (black trace) and Al0.7Sc0.3N (red trace) films and ScN (blue trace) powder; (b) Fourier transform magnitude of the k2-weighted EXAFS spectra shown in panel (a). The k-range used for the Fourier transform was 2–9 Å–1.
Figure 6
Figure 6
Fourier transform magnitude of k2-weighted EXAFS spectra of (a) Al0.75Sc0.25N; (b) Al0.7Sc0.3N; (c) ScN, accompanied by theoretical fits. Best fit parameters are tabulated in Table 2. The k-ranges used in the Fourier transform were 2.5–9.5 Å–1 for Al0.75Sc0.25N and Al0.7Sc0.3N and 3–11 Å–1 for ScN. The r-ranges used were 1.0–2.205, 1.0–2.607, and 1.0–3.229 Å for Al0.75Sc0.25N, Al0.7Sc0.3N, and ScN, respectively.
Figure 7
Figure 7
(a) Measured (black curve) and calculated (blue curve) XANES spectra of a Al0.75Sc0.25N thin film; (b) measured (black curve) and calculated (red curve) XANES spectra of ScN powder.
Figure 8
Figure 8
(a) X-ray photoelectron spectra of the binding energy of N 1s and Sc 2p electrons in Al0.75Sc0.25N (blue trace) and Al0.7Sc0.3N (red trace) thin films and ScN (black trace) powder samples. Profile fitting was performed for each of the three samples: (b) ScN; (c) Al0.7Sc0.3N; (d) Al0.75Sc0.25N in order to estimate the amplitude of the observed increase in Δ with increase in Sc doping in the wurtzite lattice.
Figure 9
Figure 9
(a) Normalized Y K-edge XANES spectrum of Al0.75Y0.25N. For comparison, the spectra of Y foil and Y2O3 are included. (b) The k2-weighted EXAFS spectra of Al0.75Y0.25N thin film, Y2O3 powder, and Y foil. (c) Fourier transform magnitude of the k2 -weighted χ(k) spectra. The k range for the Fourier transformation is 2–7.5 Å–1.
Figure 10
Figure 10
Measured (black curve) and fitted (red curve) Fourier transform magnitude of the k2-weighted EXAFS spectrum for (a) Y foil. The k range for the Fourier transform is 2–12 Å–1. The r range is 2.6–4 Å; (b) Al0.75Y0.25N film. The k range for the Fourier transform is 2–7.5 Å–1. The r range is 1.3–3.3 Å.

References

    1. Aigner R.; Kaitila J.; Ella J.; Elbrecht L.; Nessler W.; Handtmann M.; Herzog T. R.; Marksteiner S.. Bulk-Acoustic-Wave Filters: Performance Optimization and Volume Manufacturing. In 2003 IEEE MTT-S International Microwave Symposium Digest, Vols 1–3, 2001–2004; IEEE, 2003.
    1. Elfrink R.; Kamel T. M.; Goedbloed M.; Matova S.; Hohlfeld D.; van Andel Y.; van Schaijk R. Vibration energy harvesting with aluminum nitride-based piezoelectric devices. J. Micromech. Microeng. 2009, 19 (9), 094005 10.1088/0960-1317/19/9/094005. - DOI
    1. Mayrhofer P. M.; Riedl H.; Euchner H.; Stoger-Pollach M.; Mayrhofer P. H.; Bittner A.; Schmid U. Microstructure and piezoelectric response of YxAl1-xN thin films. Acta Mater. 2015, 100, 81–89. 10.1016/j.actamat.2015.08.019. - DOI
    1. Uehara M.; Shigemoto H.; Fujio Y.; Nagase T.; Aida Y.; Umeda K.; Akiyama M. Giant increase in piezoelectric coefficient of AlN by Mg-Nb simultaneous addition and multiple chemical states of Nb. Appl. Phys. Lett. 2017, 111 (11), 112901 10.1063/1.4990533. - DOI
    1. Sandu C. S.; Parsapour F.; Mertin S.; Pashchenko V.; Matloub R.; LaGrange T.; Heinz B.; Muralt P. Abnormal Grain Growth in AlScN Thin Films Induced by Complexion Formation at Crystallite Interfaces. Phys. Status Solidi A 2019, 216 (2), 1800569 10.1002/pssa.201800569. - DOI

LinkOut - more resources