Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 1982 Aug;80(2):279-97.
doi: 10.1085/jgp.80.2.279.

Influence of temperature upon contractile activation and isometric force production in mechanically skinned muscle fibers of the frog

Influence of temperature upon contractile activation and isometric force production in mechanically skinned muscle fibers of the frog

R E Godt et al. J Gen Physiol. 1982 Aug.

Abstract

Increasing temperature (4-22 degrees C) increases the Ca2+ concentration required for activation of mechanically skinned frog muscle fibers. The pCa required for 50% maximal force (pCa50) was inversely proportional to absolute temperature. Assuming that relative force is directly related to fractional occupancy of the Ca2+-binding sites on troponin that regulate force, the shift was consistent with a Gibbs free energy change of binding (delta G) of about -7.8 kcal/mol. This is close to the delta G for Ca2+ binding to the calcium-specific sites on troponin C reported by others. Decreasing Mg2+ from 1 mM to 60 microM shifts the force-pCa curves at either 4 or 22 degrees C to higher pCa, but the shift of pCa50 with temperature over this range (0.4 log units) was the same at low and high Mg2+. Maximal force increased with temperature for the entire range 4-22 degrees C with a Q10 of 1.41, and over the restricted range 4-15 degrees C with a Q10 of 1.20. From the dual effects of temperature on Ca2+ activation and maximal force, one would expect that force would respond differently to temperature change at high or low Ca2+. At high Ca2+, a temperature increase will lead to an increased force. However, at low to intermediate Ca2+ levels (below the intersection of the force-pCa curves for the initial and final temperatures), steady state force should decrease with increasing temperature. The inverse responses should occur with a decrease in temperature. These responses are observed when temperature is changed by rapid solution exchange.

PubMed Disclaimer

Publication types